Graco SlimFit3 LX User Manual

Rear Facing with Lower Anchor Attachment
4-C
49
10. Tighten the Lower Anchor Strap
Press down firmly in the center of the car seat
while tightening the lower anchor strap.
You may need to tighten the
lower anchor strap through
the rear-facing belt path to
get a tight fit.
12. Check the Level Indicator
Vehicle MUST be on level ground. Ball must be
completely in the blue area. Readjust the recline if
needed.
If needed, rolled towels may be placed under the
car seat at the vehicle seat crease, until the base
is completely in the blue area.
See section 6-A to secure your child.
Recheck the level indicator with child in seat.
11. Test For Tightness
Grab the sides of the seat where the lower anchor
strap is and slide the car seat side-to-side and
front-to-back.
If the seat moves less than 1” (2.5 cm), it is tight
enough.
NWL0001077519C SlimFit3 LX USA ENG R04 (8BZ20.indd 49NWL0001077519C SlimFit3 LX USA ENG R04 (8BZ20.indd 49 9/18/20 11:49 AM9/18/20 11:49 AM

Graco SlimFit3 LX Specifications

General

Product Type	3-in-1 Car Seat
Rear-Facing Weight Capacity	5-40 lbs
Forward-Facing Weight Capacity	22-65 lbs
Booster Mode Weight Range	40-100 lbs
Height Capacity	Up to 57 inches
Harness Type	5-point harness
Harness Positions	10
Side Impact Protection	Yes
Cup Holders	2
Machine Washable Cover	Yes
Weight Capacity	5-100 lbs
Installation	LATCH
Recline Positions	4