Graco SlimFit3 LX User Manual

Vehicle Information
10
35
Tips for Each Mode of Use
3-B
35
Three-Across Checklist
3-C
35
• Car seats can touch, but should not overlap.
Make sure the base and seat are touching the
vehicle seat firmly when installed.
• Car seat should not move more than 1” at the
belt path and each seat should be independently
secure.
• If using an infant car seat (A) next to the
SlimFit3™ LX, ensure that the infant carrier is
attached into the base at all four attachment
locations each time you install the carrier into
the base. To check this, listen for the ‘click’ and
lift up on the carrier to verify that both sides of
the base are attached and are not caught on the
seat beside it.
A
3-C Three-Across Checklist
NWL0001077519C SlimFit3 LX USA ENG R04 (8BZ20.indd 35NWL0001077519C SlimFit3 LX USA ENG R04 (8BZ20.indd 35 9/18/20 11:49 AM9/18/20 11:49 AM

Graco SlimFit3 LX Specifications

General

Product Type	3-in-1 Car Seat
Rear-Facing Weight Capacity	5-40 lbs
Forward-Facing Weight Capacity	22-65 lbs
Booster Mode Weight Range	40-100 lbs
Height Capacity	Up to 57 inches
Harness Type	5-point harness
Harness Positions	10
Side Impact Protection	Yes
Cup Holders	2
Machine Washable Cover	Yes
Weight Capacity	5-100 lbs
Installation	LATCH
Recline Positions	4