Graco SlimFit3 LX User Manual

Care & Cleaning
11
112
11-B Cleaning Buckle
Recline the car seat and locate the metal
retainer. Rotate the metal retainer up through
the shell and pad. From the front, pull the
buckle strap out.
To clean buckle, place in a cup of warm water
and gently agitate the buckle. Press the red
button several times while in the water.
DO NOT SUBMERGE THE BUCKLE STRAP. DO
NOT USE SOAPS, HOUSEHOLD DETERGENTS
or LUBRICANTS.
Shake out excess water and allow to air dry.
Repeat steps as needed until it fastens with a
click. Re-insert the buckle into the same slot it
was removed. Pull up on buckle strap to make
sure it is secured.
WARNING! Inspect and clean buckle from
time to time to remove any objects or
debris that could prevent latching.
NWL0001077519C SlimFit3 LX USA ENG R04 (8BZ20.indd 112NWL0001077519C SlimFit3 LX USA ENG R04 (8BZ20.indd 112 9/18/20 11:50 AM9/18/20 11:50 AM

Graco SlimFit3 LX Specifications

General

Product Type	3-in-1 Car Seat
Rear-Facing Weight Capacity	5-40 lbs
Forward-Facing Weight Capacity	22-65 lbs
Booster Mode Weight Range	40-100 lbs
Height Capacity	Up to 57 inches
Harness Type	5-point harness
Harness Positions	10
Side Impact Protection	Yes
Cup Holders	2
Machine Washable Cover	Yes
Weight Capacity	5-100 lbs
Installation	LATCH
Recline Positions	4