Graco SlimFit3 LX User Manual

Accessories
9
96
Harness Covers
Make sure that harness covers do not interfere
with placement of the chest clip at armpit level.
To remove, undo the fastening strips and remove.
When forward-facing, harness covers MUST be
used if the child weighs 25 lb (11 kg) or less.
Infant Body Support
Use only in the rear-facing mode.
Body support must be used if shoulders are below
the lowest harness setting.
Never allow body support to bunch or fold behind
child.
Infant Head Support
Use only in the rear-facing mode. To adjust the
support, pull up until desired height.
To install, thread the head support straps through
the headrest and use the fastening strips to
connect the straps together.
To remove, undo the fastening strips and pull the
straps out of the headrest.
9-A Accessories (on select models)
NWL0001077519C SlimFit3 LX USA ENG R04 (8BZ20.indd 96NWL0001077519C SlimFit3 LX USA ENG R04 (8BZ20.indd 96 9/18/20 11:50 AM9/18/20 11:50 AM

Graco SlimFit3 LX Specifications

General

Product Type	3-in-1 Car Seat
Rear-Facing Weight Capacity	5-40 lbs
Forward-Facing Weight Capacity	22-65 lbs
Booster Mode Weight Range	40-100 lbs
Height Capacity	Up to 57 inches
Harness Type	5-point harness
Harness Positions	10
Side Impact Protection	Yes
Cup Holders	2
Machine Washable Cover	Yes
Weight Capacity	5-100 lbs
Installation	LATCH
Recline Positions	4