Grandstream Networks GRP2636 User Manual

Table 15: Configuration Menu
The following picture shows the keypad MENU configuration flow:
● 802.1X:Enables/Disables 802.1X mode; Configures 802.1x identity and MD5 password.
● Layer 2 QoS: Configures 802.1Q/VLAN Tag and priority value. Select “Reset VLAN Config” to
reset VLAN configuration.
–Wi-Fi Settings (GRP2612W, GRP2614, GRP2615, GRP2616, GRP2624, GRP2634, GRP2670 &
GRP2650 only):
● Enables/disables Wi-Fi:Enables/disables Wi-Fi
● Scan:Enables/disables Wi-Fi
– Bluetooth Settings (GRP2614/GRP2615, GRP2616, GRP2624, GRP2634, GRP2670 & GRP2650
only):
● Bluetooth Status:Displays the status of Bluetooth
● Bluetooth MAC: Displays the GRP phone’s Bluetooth MAC address.
3. (Bluetooth MAC address is GRP phone’s MAC address plus 1)
● Power:Turns on/off the Bluetooth feature.
● Handsfree Mode:Enables/Disables Handsfree mode
● Bluetooth Name: Specifies GRP phone name when discovered by other Bluetooth devices.
● Start Scan:Starts to scan other Bluetooth devices around the phone. If found, user could press
“Pair” Softkey, and enter Pin code to pair to other Bluetooth devices.
– Web Access:
● Web Access Mode
● HTTP web port
● HTTPs web port
– Upgrade:
● Firmware Server:Configures firmware server for upgrading the phone.
● Config Server:Configures config server for provisioning the phone.
● Upgrade Via:Specifies upgrade/provisioning via TFTP/FTP/FTPS/HTTP/HTTPS.
● Start Provision:Starts Provision immediately.
– Language Download:
● Auto Language Download
● Language Download
– Factory Functions:
● Diagnostic Mode:All LEDs will light up. All keys’ name will display in red on LCD screen before
diagnosing. Press any key on the keypad to diagnose the key’s function. When done, the key’s
name will display in blue on LCD. Lift and put back the handset to exit diagnostic mode.
● Audio Loopback: Speak to the phone using speaker/handset/headset. If you can hear your
voice, your audio is working fine. Press “Exit” Softkey to exit audio loopback mode.
● LCD on/off:Selects this option to turn off LCD. Press any button to turn on LCD.
● LCD Diagnostic:Selects this option to turn off LCD. Press any button to turn on LCD.
● Certificate Verification:This is used to validate certificate chain for the server’s certificate.
– UCM Detect:
Detect/connect UCM server to process auto-provision. Manually input the IP and port of the UCM
server phone wants to bind with; Or select from the available UCM server in network.
– Authentication:
● Admin Password:This is used to change the admin password for Web UI access.
● End User Password:This is used to change end user password for Web UI access.
● Settings:Turns on/off Test Password Strength feature. This will allow only passwords with
some constraints to ensure better security.
– Operation:
● Factory Reset:It is used to restore the phone to factory default settings.
● Ping and Traceroute:It is used to show the route taken by packets across to an URL.
● Alternative firmware:It is used to show current and alternative firmware versions available on
the phone. Users can “rollback” to alternative firmware from this menu.
Reboot Reboots the phone.

Grandstream Networks GRP2636 Specifications

General

Brand	Grandstream Networks
Model	GRP2636
Category	IP Phone
Language	English