HT801/HT802 Administration Guide
Version 1.0.13.7
Check New Firmware only
when F/W pre/suffix changes
Configure the HT801/HT802 to search for the new firmware when the
firmware prefix / suffix changes.
When this option is selected, the HT801/HT802 will check for updates only
when the pre/suffix has been changed.
Always Skip the Firmware
Check
Configures the HT801/HT802 to skip the firmware check, when this option
is selected the HT801/HT802 will always skip searching for a new firmware.
Disable SIP NOTIFY
Authentication
Disables the SIP NOTIFY Authentication on the phone adapter. If set to
“Yes”, the phone adapter will not challenge NOTIFY with 401.
The default setting is “No”
Authenticates configuration before being accepted. This protects the
configuration from unauthorized modifications. Default is No.
Validate Server Certificates
This feature allows users to validate server certificates with our trusted list
of TLS connections. The device needs to reboot after changing the setting.
Default is enabled. DDNS
Specifies SSL certificate used for SIP over TLS is in X.509 format. The
HT801/HT802 has built-in private key and SSL certificate.
Specifies TLS private key used for SIP over TLS is in X.509 format.
SIP TLS Private Key
Password
Specifies SSL Private key password used for SIP Transport in TLS/TCP.
Custom Certificate
(Private Key + Certificate)
Allows users to update to the device their own certificate signed by custom
CA certificate to manage client authentication.
Sets the phone adapter system to enable the “CPE WAN Management
Protocol” (TR-069). Default setting is No.
Specifies URL of TR-069 Auto Configuration Servers (e.g.,
http://acs.mycompany.com), or IP address.
Enters username to authenticate to ACS.
Enters password to authenticate to ACS.
Sends periodic inform packets to ACS. Default is No
To Next Page
Loading...
Need help?
General
