Grant Aerona - System Configuration with Touchscreen Display; Initial Controller Setup: First Switch-On; Using the System Configuration Creator

Section 6: System Conguration with Touchscreen Display Page 19
6 System Conguration
with Touchscreen display
6.1 FIRST SWITCH-ON
With installation completed, the Grant Aerona Smart controller will
need to be congured:
1. Turn on the Grant Aerona Smart controller via the wiring
centre power switch (Refer to Figure 5-1) and allow the
software to cycle to the language selection panel. (Refer to
Figure 6-1).
Language
Figure 6-1: Language selection
2. Select required language preference and conrm with >.
Date
2023 10
02
Figure 6-2: Setting date
3. Set the date. Tap the ˄ & ˅ to amend the values for year ,
day and month. Conrm with >. Refer to Figure 6-2.
Time
0614
Figure 6-3: Setting time
4. Set the time. Tap the ˄ & ˅ to amend the time & conrm with
>. Refer to Figure 6-3.
5. The touchscreen will progress to ask if you wish to start a
conguration. Tap
üü to start the conguration creator. Refer
to Figure 6-4 and Section 6.2.
System configuration creator
Would you like to start configuration?
Figure 6-4: Conguration creator
6. If you tap X the controller will take you to the home screen
and display 'No circuits dened'. Refer to Figure 6-5.
No Circuits Defined
Figure 6-5: No circuits dened
7. To access the system conguration creator you need to
access the settings menu / service settings menu. See
Section 7 Table 7-1. The service settings password is 0000.
6.2 SYSTEM CONFIGURATION CREATOR
The Grant Aerona Smart Controller integrated system
conguration creator will aid with the setup of the space heating
and DHW system within the software of the touchscreen display.
The steps in the conguration creator should reect the system
you have designed and electrically connected to the wiring centre.
You must only congure components you have connected (Refer
to Section 5 Figure 5-3 for wiring centre layout).
! NOTE !
Ensure you pay close attention to the devices you connect
to the wiring centre and conrm for correct operation.
Using the system you have planned you can follow the system
conrguration creator steps to congure it within the Grant Aerona
Smart controller. (Refer to Figure 6-6 for System conguration
map).