Grant Aerona - econET24 Internet Access and Registration; First Connection and UID Acquisition

Section 10: Wi-Fi HubPage 36
10.4 ECONET24
The Wi-Fi hub connects to ecoNET24 via an external server
connection. This provides access to the controller via the Internet.
You will need an account to log into the the external server, visit
www.econet24.com on a web browser to register.
10.4.1 FIRST CONNECTION
Ensure the Wi-Fi hub will need is connected to the Internet and
connected with the external server ('Server connection' LED
indicator is active).
The device UID (which is obtained via User settings menu in
Device Diagnostics) will be needed as part of the registration
process. Refer to Section 10.4.2 for details.process. Refer to Section 10.4.2 for details.
On a web browser visit www.econet24.com. When registering you
will be prompted to validate the device UID. If the system correctly
validates the UID number, the registration will progress. Complete
the form with the data of the user.
• Controller UID
• Controller label – enter any name for the Smart Controller.
• Remote access to the controller – enables remote access to
view and edit controller parameters.
• Controller installation address – check that the Smart
Controller address is the same as residential address.
• Alarm notications – E-mail notications of alarms can be
sent to a designated address.
! NOTE !
To use the app you will need to register via Website rst.
For a reminder of a password for an existing account, select
FORGOT PASSWORD and enter your email. A password
reminder will be sent to your email account.
10.4.2 HOW TO OBTAIN THE UID
Follow the steps to obtain the UID.
1. When the heating circuit control interface is shown (see
gure 7-1), tap settings menu. Refer to Table 7-1 and Figure
10-4.
2. Then tap the User settings. Refer to Figure 10-5.
---
User settings
Service settings
User settings
04.10.2024
100
100%
Time
Date
Panel address
Language
Parental lock
Screen brightness
User settings
Diagnostic info
Alarm list
Firmware version
Firmware update
Firmware version
Panel
Controller
Serial number
UID
S002.11 h1.0.0 C14.01.05
S002.04 h2.3.0
1234567890
12ABCDEF456GHIJ78KL9MNP
ISM
Figure 10-4: Settings selection.
Figure 10-5: User settings menu.
3. Tap the information icon at the bottom. Refer to Figure 10-6.
Figure 10-6: Controller information options.
4. Then tap 'Firmware version'. Refer to Figure 10-7.
Figure 10-7 Firmware version and UID.
10.4.3 RESTORING TO DEFAULT
If you should experience any issues during setup or the user
forgets their details for logging in the Wi-Fi hub, it is possible to
restore default data with the use of the WPS/Reset button on the
hub housing.
• Push and hold WPS/RESET for at least 10 seconds.
• Release the WPS/RESET button. LED indicator above
should ash several times.
• Wait for approx. 2 minutes.
• The hub will automatically start up and connect with the
Internet using default username and password.
! NOTE !
Default username: admin, password: admin