EasyManua.ls Logo

Grant Aerona - Service Settings for Installers; Installation Control Menu Options; Manual Control of System Components; Main Heat Source Settings

Grant Aerona
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 8: Service Settings - InstallerPage 30
8 Service Settings - Installer
Default settings
Restore default settings
Save current settings as default
Flow meter
Flow meter
Specic Heat capacity
Time detect*
Time alarm erase*
No ow detection threshold*
No ow detection hyst.*
Pulse rate
Pulse counting time*
Too often alarm*
Heaters
Bu󰀨er heater
DHW heater
Circuit 2&3
Circuit support
Circuit name
Circuit type
Pump only
Circuit stop from preset Temp.
Heating circuit
Regulation method
Work mode
Decrease water temperature
Minimal Temp.
Maximum Temp.
Heating curve
Thermostat
Room temperature correction
Thermostat pump blockade
Valve Opening Time (UFH)
Mixer deadband zone (UFH)
Proportional range (UFH)
Intergration time constant (UFH)
Circuit 1
Circuit support
Circuit name
Regulation method
Work mode
Heating circuit
Fixed preset water temperature
Decreasing xed water temperature
Heating Curve
Decrease water temperature
Thermostat
Room temperature correction
Thermostat pump blockade*
Circulation settings
Circulation support
Circulation operation time
Circulation pause time
Start from temperature
Pump start temperature
DHW settings
DHW support
Low Loss Header settings
Additional temp. sensor
Water preset temperature
Preset temperature hysteresis
Bu󰀨er settings
Bu󰀨er operation type
Preset temperature
Preset temperature hysteresis
Heating installation start temp.
Main heat source
DHW temp. correction
Circuit temp. Correction
Set-point temp. correction – heating
Weather sensor
External temp. sensor support
Temp. sensor source
SUMMER mode activation temperature
WINTER mode activation temperature
Installation control
Manual control
Weather sensor
Hydraulic scheme
Main heat source
Bu󰀨er settings*
Low Loss Header settings*
DHW settings
Circulation settings*
Circuit 1-3
Heaters
Flow meter*
Additional Modules
Default settings
Service Settings (Password: 0000)
Installation control
System conguration creator
Alarm list
! NOTE !
Items within the menu will change depending on
congured system.
Figure 8-1: System settings menu map

Table of Contents

Related product manuals