IMPORTANT NOTE FOR INSTALLERS
These instructions are intended to guide installers on the
installation and commissioning of the Grant Aerona Smart
Controller intended for use with Grant Aerona air source heat
pumps. After installing the unit, leave these instructions with the
user.
SPECIAL TEXT FORMATS
The following special text formats are used in these instructions
for the purposes listed below:
! WARNING !
Warning of possible human injury as a consequence of not
following this instruction.
! CAUTION !
Caution concerning likely damage to equipment or tools as
a consequence of not following this instruction.
! NOTE !
Used for emphasis or information not directly concerned
with the surrounding text but of importance to the reader.
GRANT ENGINEERING (UK) LIMITED
Frankland Road, Blagrove Industrial Estate, Swindon, SN5 8YU
Tel: +44 (0)1380 736920 Fax: +44 (0)1380 736991
Email: info@grantuk.com www.grantuk.com
This manual is accurate at the date of printing but will be superseded and should be disregarded if specications and/or appearances are changed in the interests of continued product improve-
ment. However, no responsibility of any kind for any injury, death, loss, damage or delay however caused resulting from the use of this manual can be accepted by Grant Engineering (UK)
Limited, the author or others involved in its publication.
All good sold are subject to our ocial Conditions of Sale, a copy of which may be obtained on application.
© Grant Engineering (UK) Limited. No part of this manual may be reproduced by any means without prior written consent.
PRODUCT CODES AND SERIAL NUMBERS
COVERED
The serial numbers used on Grant Aerona Smart Controller
consist of a ten digit numerical code.
For example:
1006986828
This serial number can be found on a label attached to the wiring
centre.
! CAUTION !
Electric device under voltage!
Before any action related to the power supply (cables
connection, device installation etc.) Check to ensure the
controller is not connected to the mains power. Installation
should be done by a person with appropriate electrical
qualications. Improper cable connection could result in
controller damage. The controller must not be installed in
steamy conditions or exposed to water, such as bath or
shower room
To Next Page
Loading...
