3-2 CHAPTER 3. CRAFT ROBO CONTROLLER
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
CH 3. CRAFT ROBO CONTROLLER
CH 4. CUTTING DATA SAVED ON SD CARD
APPENDIX A INDEX
When auto play of software is not set
• For Windows Vista:
1. Select [Run MultiSetup.exe] from [Autoplay] Selection menu of Windows.
• When [Autoplay] Selection menu does not appear:
1. Select the CD-ROM Drive from Computer, and select [Open] with a right click.
2. Double-click [MultiSetup.exe].
* For Windows XP/2000, operate in the same manner.
(2) Click the [Craft ROBO Lite (CC300-20/CC300L-20) Software Install] or [Craft ROBO (CC330-
20/CC330L-20) Software Install] button according to your model.
To Next Page
Loading...
