CE6000-UM-251-9370 7-27
7 ELECTRICAL ADJUSTMENTS
(10) Press the ENTER key to store the value.
Skip to step (18)
(11) When the X-front media or the X-rear media or the Registration-mark sensor are replaced press the
F1 key (ADJ.START (Spc. Media)).
(12) Press the F3 key (SHEET) when the following menu is displayed.
The plotter scan the paper size.
Then the plotter scan the edge of adjustment sheet, and then it automatically adjust the front and the
rear media sensor position with the registration mark sensor position.
(13) The following menu is displayed.
(14) Press the F4 key (CONFIRM X EDGE POS.).
The front edge of adjustment sheet
moves to as shown in the picture below.
Cutting mat base
Conrm the front edge of adjustment sheet come to this front area of
cutting mat base.
The front edge of adjustment sheet
To Next Page
Loading...
