GRAPHTEC Craft ROBO CC200 - Allowable cutting area of the carrier sheet; Carrier Sheet

CHAPTER 2. CONNECTION AND PREPARATION 2-9
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
Allowable cutting area of the carrier sheet
The allowable cutting area of the carrier sheet is shown in the diagram below.
When using media smaller than A4 size, always affix the media within the allowable cutting area. In
addition, make sure that the edges of the media are parallel to the edges of the carrier sheet.
CHECKPOINT
Do not use media smaller than postcard size (100 x 148 mm).
Allowable 
cutting area
Allowable 
cutting area
Media
190mm
5mm
20mm
10mm 10mm