GRAPHTEC Craft ROBO CC200 - 2.3 Loading Media

CHAPTER 2. CONNECTION AND PREPARATION 2-3
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
2.3 Loading Media
Media loading method
(1) Press the standby switch to turn on the power, and confirm that the lamp on the standby switch
is lit (blue).
(2) Load the sheet in the Craft ROBO.
Align the left edge of the sheet with the vertical guideline indented on the front guide. Place the
top edge of the sheet against both pinch rollers, making sure that the sheet is straight.
CHECKPOINT
If a sheet wider than 210 mm is loaded, the guideline will be covered by the sheet.
However, if the sheet is loaded so that its top edge touches and is parallel to both the
pinch rollers, it will be straight.
To ensure that the loaded sheet is straight,
align the left edge of the sheet with the 
guideline indented on the front guide.
Place the top edge of the sheet against 
both pinch rollers.
Guideline indented
on the front guide
If you are using media that is not A4 size, please follow the instructions given below.
• If the media size is smaller than A4 size
Use the carrier sheet. (Please see Section 2.4, "Carrier Sheet".)
• If the media width is between 210 and 260 mm
If the width of the sheet is between 210 and 260 mm, the only types of media that can be
loaded are vinyl film or tack paper.
• If the media length is between 297 and 1000 mm
The accuracy specification is guaranteed for sheets that measure 210 x 297 mm, but if the
media is film (with a thickness of 0.1 mm or less, and 0.3 mm or less including the backing
sheet), lengths up to 1000 mm can be loaded.