3-12 CHAPTER 3. CRAFT ROBO CONTROLLER
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
Blade Position .............. Use these buttons to move the position of the blade or the pen (ballpoint pen)
mounted in the Craft ROBO.
When the left-hand or right-hand buttons are pressed, the blade or the pen
(ballpoint pen) is moved to the left or right. When the up or down buttons are
pressed, the media is moved. Clicking the [Use Keyboard] button allows the arrow
keys on the keyboard to be used in the same way as the [Blade Position] buttons.
Set Origin ...................... Use this button to specify the origin point of the cutting area.
After moving the blade or pen (ballpoint pen) to the desired origin point using the
[Blade Position] buttons, click the [Set Origin] button to specify the current position
as the origin. This function cannot be used (is not required) when registration marks
are used for positioning.
Landscape orientation Portrait orientation
If the origin point has not been specified, and Landscape has been selected for the
media orientation, the origin point is located in the vicinity of the red circle in the
left-hand diagram. If Portrait has been selected for the media orientation, the origin
point is located in the vicinity of the blue circle shown in the right-hand diagram.
CHECKPOINT
When moving the origin, be sure to take the size of the design to be cut
into account. If the origin point is not set correctly, the part of the design
that extends past the edges of the media as shown below will not be cut
(or plotted).
Origin poin
Cut line
Cutting/plotting range
Loaded media
CHECKPOINT
The "Set Origin" function cannot be used when the "Registration Marks"
check box has been selected.
To Next Page
Loading...
