GRAPHTEC Craft ROBO CC200 - S; T; U; W

I-2 INDEX
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
Registration mark reading .....................................3-14
Registration Mark Sensor Position Correction ......3-15
Registration Marks ......................................3-13, 3-14
S
Search Registration Marks....................................3-13
Set Origin ..............................................................3-12
Standard Specifications ......................................... A-1
Standby switch ........................................................1-2
[Start] window .........................................................3-2
T
Test Cut .................................................................3-11
Test Plotting.............................................................3-7
Thickness ..............................................................3-10
Track Enhancing....................................................3-11
U
USB cable ...............................................................1-1
USB interface connector .........................................1-2
W
Warning ....................................................................... i
What to Do if This Happens ..................................2-15