APPENDIX A-1
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
APPENDIX
Appendix A. Standard Specifications
Item Specification
Feeding method Grit-rolling
Drive Stepping motor
Cutting range Maximum: 200 x 1000 mm (in expanded mode)
Limited, however, to film media only (0.1 mm or less in thickness,
liner-included thickness of 0.3 mm or less)
Effective sheet width A4 size supported
Loadable sheet width: maximum 260 mm, minimum 210 mm unless
the carrier sheet is used
Operating speed 10 - 100 mm per second (in 10-mm steps; 10 levels selectable)
Loadable number of blades/pens 1
Tools Blade with dedicated blade holder
General-purpose ballpoint pen (used only with the ballpoint pen
holder)
Media types that can be cut Film media 0.1 mm or less in thickness, liner-included thickness of
0.3 mm or less (but excluding high-intensity reflective sheets), Kent
paper (inkjet or laser paper up to 157 g/m
2
), drawing paper,
postcards, scrapbooking paper; inkjet photo paper
* Not all types of media can be cut
Interface USB 2.0 (Full speed)
Rated power supply Dedicated adapter, +24 V DC (2.0 A)
Power consumption 28 W (10 W or less during standby)
Working environment 5 to 40˚C, 35 to 80% R.H. (Non-condensing)
Guaranteed operating environment 16 to 32˚C, 35 to 70% R.H. (Non-condensing)
External dimensions (W x D x H) Approx. 397 x 159 x 112 mm (excluding protrusions)
Weight Approx. 2.2 kg
To Next Page
Loading...
