CHAPTER 2. CONNECTION AND PREPARATION 2-13
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
2.6 Mounting a ballpoint pen
Acceptable ballpoint pens
The ballpoint pen holder accepts the following pen types:
(1) Cylindrical ballpoint pens: Up to 8.5 mm in diameter
(2) Hexagonal ballpoint pens: Up to 7.5 mm side-to-side
(3) The tips of both pen types must extend between 3 and 3.5 mm past the ballpoint pen holder's
opening.
Hexagonal
ballpoint pen
Cylindrical
ballpoint pen
Ballpoint
pen holder
Thumb screw
Pen tip
3 to 3.5mm
7.5mm
φ8.5mm
To Next Page
Loading...
