GRAPHTEC Craft ROBO CC200 - 2.1 Connecting and Powering On

CHAPTER 2. CONNECTION AND PREPARATION 2-1
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
CHAPTER 2. CONNECTION AND PREPARATION
2.1 Connecting and Turning on the Power
Use the AC adapter and the power cable provided with the Craft ROBO to connect the AC adapter jack on
the Craft ROBO to an AC outlet of the rated voltage, and then turn on the power.
CHECKPOINT
Always connect the AC adapter to the AC adapter jack before connecting the power cable to the AC
outlet.
(1) Connect the power cable (included with the AC adapter) to the AC adapter.
(2) Plug the AC adapter cable into the AC adapter jack of the Craft ROBO.
(3) Plug the other end of the power cable into the AC outlet.
(1)
(2)
(3)
(4) Press the standby switch to turn on the power.
When the Craft ROBO is in power-on status, the lamp on the switch is lit blue.
When the Craft ROBO is in power-off status, the lamp on the switch is extinguished.