GRAPHTEC Craft ROBO CC200 - 2.7 Troubleshooting Common Issues

CHAPTER 2. CONNECTION AND PREPARATION 2-15
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
2.7 What to Do if This Happens
Thick or dense media like a photo paper may be cut when it is cut twice
• If you use "ROBO Master", CraftROBO cut media twice when you copy and paste the object at the
same place on the ROBO Master.
• If you use "Cutting Master 2 for Craft ROBO", you can set how many times cut at "Passes" on
Advanced Tab.
The blade no longer cuts cleanly
• If dirt or dust has adhered to the blade, remove the blade adjustment cap and then remove any
dirt from around the blade.
• Start up the Craft ROBO Controller, select the "Adjust Settings" check box, and then increase the
value by one in the "Thick" direction.
• Replace the cutter blade with a new one.
• Wipe the cutting head shaft with a lint-free cloth.
Shaft
An abnormal noise is generated with the power is turned on, and the cutting head
does not move smoothly.
• Wipe the cutting head shaft with a lint-free cloth.