2-2 CHAPTER 2. CONNECTION AND PREPARATION
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
2.2 Connecting to a Computer
The USB interface connectors are used to connect the Craft ROBO to a computer.
Use the USB cable provided with the Craft ROBO to connect the Craft ROBO to a computer.
CHECKPOINT
• The software for the Craft ROBO must be installed before the Craft ROBO is connected to a
computer. (See Chapter 3.3, "Installing the Craft ROBO Controller".)
• Do not connect the USB cable until instructed to do by an on-screen prompt.
The USB cable has different plug shapes on the computer side and the Craft ROBO side. Always
check which plug connects to which side.
CHECKPOINT
• Do not connect two or more Craft ROBO units to one computer.
• Do not connect the Craft ROBO and a Graphtec plotter to a computer at the same time. If
you do so, the Craft ROBO may not operate properly.
To Next Page
Loading...
