CHAPTER 3. CRAFT ROBO CONTROLLER 3-17
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
If the position of the intersection point recognized by the Craft ROBO is not
aligned with that of the printed cross, correct it as specified below.
Use the vertical (y) or horizontal (x) scroll bar to specify a correction value.
The correction value must be in the range of –40 to 40. One step represents
0.05 mm. For example, if 20 is specified as the correction value, the line drawn
by the pen (ballpoint pen) moves 1 mm.
If the position of the intersection point recognized by the Craft ROBO is not
aligned with that of the printed cross, set a correction value in accordance with
the figures shown below. The red circle in each diagram denotes the position of
the intersection point recognized by the Craft ROBO.
Craft ROBO
Horizontal (x)
Vertical (y)
Craft ROBO
Craft ROBO
Craft ROBO
If the cross is located at
this position, move it
toward the positive side
in both the horizontal (x)
and vertical (y) directions.
If the cross is located at this
position, move it toward the
negative side in the horizontal (x)
directions and toward the
positive side in the vertical (y)
directions.
Horizontal (x)
Vertical (y)
If the cross is located at
this position, move it
toward the positive side
in the horizontal (x)
directions and toward the
negative side in the
vertical (y) directions.
Horizontal (x)
Vertical (y)
If the cross is located at
this position, move it
toward the negative side
in both the horizontal (x)
and vertical (y) directions.
Horizontal (x)
Vertical (y)
Distance Correction ..... When the Craft ROBO moves the media, the distance by which the media is fed
may not always be exactly as expected, depending on the media thickness and
cutting speed. Distance Correction is used to account for such an error. In the
range of –2% to +2%, enter a negative value if the fed distance is greater than the
expected distance, or a positive value if the fed distance is less than the expected
distance. The correction value may be calculated from the equation below.
1 – x 100 = correction value
Actually moved distance
Distance to be moved
Concrete example ........ If the media needs to be moved 20 cm and the distance actually moved by the
Craft ROBO is 19.8 cm, then
(1 – 19.8 ÷ 20) x 100 = 1
Therefore, enter the value 1 for correction.
CHECKPOINT
It is not normally necessary to perform correction. When registration
marks are used, correction is performed automatically.
Blade Position .............. Clicking the [Use Keyboard] button allows the arrow keys on the keyboard to be
used in the same way as the [Blade Position] buttons.
To Next Page
Loading...
