GRAPHTEC Craft ROBO CC200 - Mounting the blade holder; Mounting

2-12 CHAPTER 2. CONNECTION AND PREPARATION
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
Mounting the blade holder
Mount the blade holder that has had its protruding blade length adjusted (by selecting the most
suitable blade adjustment cap) in the Craft ROBO.
Caution
When handling the cutter blade, take care not to cut your hands.
CHECKPOINT
Be sure to grip the clamp bracket firmly when mounting or removing the blade holder.
(1) Turn the lock lever to the left (OPEN direction) to loosen the clamp bracket.
Lock lever
Loosen Tighten
If you are using media that does not require the carrier sheet, mount the blade holder while
making sure that the protrusion on the holder faces the front and that it is aligned with the
notch in the clamp bracket.
If you are using the carrier sheet, turn the protrusion on the holder 90 degrees to the right so
that it fits against the protrusion on the clamp bracket.
Protrusion on the holder
Protrusion on the clamp bracket
Notch in the clamp bracket
When using media without the carrier sheet When using the carrier sheet
Front
HolderHolder HolderHolder
Protrusion on the holderProtrusion on the holder
(2) Firmly insert the blade holder in the clamp bracket and then turn the lock lever to the right
(CLOSE direction) to tighten the clamp bracket.
Firmly insert the blade holder until this 
face contacts the clamp bracket.
Note: In the diagram below, the protrusion on
the holder is facing the front.