CHAPTER 3. CRAFT ROBO CONTROLLER 3-19
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
The design orientation has not been specified correctly. Please check the "Design
Orientation" setting in your application program.
→ Make the setting once again. If the problem is still not resolved, consult the manufacturer of the
application software that you are using.
The distances between the registration marks have not been specified correctly.
Please check the "Distance between Registration Marks" setting in your application
program.
→ Make the setting once again. If the problem is still not resolved, consult the manufacturer of the
application software that you are using.
The specified Media Type cannot be used. Please specify a different Media Type.
→ The default Media Type has been specified, or characters (Ä / : * ? < >) that cannot be used for
the Media Type name have been specified. Please enter the Media Type name once again.
To Next Page
Loading...
