2-4 CHAPTER 2. CONNECTION AND PREPARATION
PREFACE
PREFACE
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
INDEX
INDEX
CONTENTS
CONTENTS
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
(3) Turn the feed knob in the direction toward the rear of the Craft ROBO to feed the sheet until its
top edge is aligned with the rear edge of the cutting mat, or with the indented guideline located
next to the cutting mat.
Feed knob
Cutting mat
Guideline located next
to the cutting mat
If the top edge of the sheet curls up and catches on the Craft ROBO, turn the feed knob in the
direction toward the rear of the Craft ROBO to align the top edge of the sheet with the indented
guidelines located behind the cutting mat. Please note, however, that the cutting area will be
reduced by 5 mm in the media feed direction.
Feed knob
Cutting mat
Guidelines located
behind the cutting mat
To Next Page
Loading...
