3-32
Settings and Measurement
(4) OPT Settings
This menu is used to specify conditions for PC connection and USER settings for switching
between users.
The USER settings allow you to read out the stored setting conditions easily by switching between
users.
(4)-1 End-of-Line Character
Specifies a New Line code used when controlling with the I/F command.
(4)-2 USB Setting
Sets the USB ID number of the GL900.
Specify a number from 0 to 9.
When you control more than one unit of the GL900 with one PC, assign a unique USB ID to each
of them
CAUTION
You must restart MT100 after any change is made to a setting value.
Changes are applied upon restart.
A screen switches
with ENTER key.
Setting Selections available
USB ID 0 to 9
IP Address 0 to 255. 0 to 255. 0 to 255. 0 to 255
Detailed Settings New Line Code CR+LF, LF, CR
USB ID 0 to 9
IP Address 0 to 255. 0 to 255. 0 to 255. 0 to 255
Subnet Mask 0 to 255. 0 to 255. 0 to 255. 0 to 255
Port Number 1024 to 65535
Gateway 0 to 255. 0 to 255. 0 to 255. 0 to 255
DNS Address 0 to 255. 0 to 255. 0 to 255. 0 to 255
Setting Condition Switching Guest, User 1, User 2
User Text input (when User is set)
Department Name Text input (when User is set)
Selection Description
CR+LF Starts a new line with CR+LF codes.
LF Starts a new line with LF code.
CR Starts a new line with CR code.
To Next Page
Loading...
