GRAVOGRAPH M40 Vice - Page 50

NOTICETECHNIQUEGAMMEM40
M40RANGETECHNICALMANUAL
Date:June2009From
AftersalesTechnicalSupport
Ref.M40GB/FF‐Vers.1.0
Page - 51
Put back the spindle holder cover and tight the 2 screws.
Replacer le carter de protection et resserrer les 2 vis.
This operation is finished, switch on the machine in order to check the correct
detection of the Z limit switch.
Opération terminée, mettre sous tension la machine afin de vérifier la bonne
détection du Switch.