105
Tag
A l p h a - n u m e r i c
text
The alphanumeric display name for
the SWPR object. Use the standard
text entry method or QTXT to name
the object.
L/Out On or Off
Permanent lockout for the SWPR
search. Also accessed by pressing
FUNC L/OUT while the scanner is
stopped on the SWPR object.
LED Mode Solid or Flash
Controls whether the ALERT LED
flashes or remains on solid when the
ALERT LED is used.
LED Color 0-7
Sets LED color to 0-7 as defined in
the GLOB menu. By default, 0=LED
Off, 1=Red, 2=Yellow, 3=Green,
4=Cyan, 5 = B l u e , 6 = M a g e n t a ,
7=White.
Latch LED On or Off
Normally the ALERT LED is active
only while the object is receiving a
transmission. When Latch is on, the
ALERT LED will remain lit after the
transmission is complete, unless
overridden by a subsequent object
that is also using the ALERT LED.
Backlight On, Off or Flash
Controls whether the backlight
should be on, off or flashing while the
object is active.
Alarm
None, Chirp, Hi-
Lo, Alert, R ing,
2-Chirp, Fast Hi-
Lo, DTMF#
Sets the Audible Alarm for the SWPR
object. When an Audible Alarm is
selected, the selected alarm will play
anytime the scanner stops for activity
on the SWPR object while scanning.
Fav Yes or No
When Yes, the SWPR object is a
member of the Favorites Scan List.
EXPERT BELOW
Atten On or Off
When on, applies 20 dB of attenua-
tion to all hits received on the SWPR
search. Useful in areas where inter-
ference from nearby strong signals is
present.
To Next Page
Loading...
