106
Delay On or Off
Controls whether a Delay is used to
wait for reply traffic after a transmis-
sion on the SWPR search.
Delay Time 1-200
Sets the amount of time (in 100 mil-
lisecond intervals) for the wait for
reply delay if Delay is On, e.g., 20=2
seconds.
Zeromatic On or Off
When on, enhances the scanner’s
ability to lock on to the actual center
frequency of a search hit instead of
an adjacent frequency.
Special On or Off
SWPR works by quickly sweeping
the RF spectrum in 1 MHz increments
to find nearby strong signals. If the 1
MHz sweep indicates that activity is
present in the 1 MHz range, SWPR
sweeps that range to find the source.
Search Dir Up or Down
Sets search direction used when
SWPR object is active.
Hit Count Numeric value
Increments each time a transmission
is received on the SWPR object.
Global “Hit Counts” must be set to
ON. Press the
Dflt
softkey to reset
to 0.
To Next Page
Loading...
