50
It is also possible to clear the FAV Scan List completely by pressing PROG,
then the
GLOB
softkey, then scrolling to down to the Clear FAV menu item.
Press the SEL key to set FAV=NO for all objects, press the
YES
softkey to
confirm the action, then press the
Save
softkey to save your changes.
For example, you may wish to leave the FAV Scan List empty, and add
your favorites while scanning by pressing FUNC, then FAV when objects of
interest are active. This can be useful during a major event, where you wish
to quickly isolate objects of interest by pressing FUNC FAV when they are
active, then pressing FAV to scan only those objects.
The Favorites Scan List is also useful to group objects that are very close to
where you live, so that when you press the FAV key, you are only scanning
objects that are in your immediate vicinity, making the radio less active and
increasing the chances that you will not miss important local activity.
Use your imagination and you will probably come up with many other ways
to use the Favorites Scan List feature.
Mapping Objects to Scan Lists
By default, every new object you create is mapped to be a member of Scan
List 01. Scan List membership is defined in an object’s parameters menu
and is typically found at the beginning of the menu.
To change Scan List membership when creating a new object, scroll up
or down to the
Scan Lists:
parameter in the object's menu before
saving the object. With the
Scan Lists:
field highlighted (as indicated
by the blinking cursor), use the
34
keys on the 5-way pushbutton pad
to scroll through the Scan Lists until you find the Scan List that you wish
to enable or disable membership for the object, and use the SEL button
to toggle membership for that Scan List on or off. The asterisk (*) next to
the Scan List number indicates that the object is a member of that Scan
List. Press the
Save
softkey to save the modified object. Objects can be
members of as many Scan Lists as you see fit, without limitation to the
number of Scan Lists an object is mapped to, and without limitation to the
number of objects that are mapped to a given Scan List.
To change Scan List membership for an existing object, press the PROG
key. Use the
3456
keys on the 5-way pushbutton pad to scroll to the
existing object that you wish to change, then press the
EDIT
softkey.
Press the
CURR
softkey to edit the current object.
NOTE: Remember, when browsing objects in Manual or Program Mode, the
arrow keys on the 5-way pushbutton pad operate as follows:
To Next Page
Loading...
