133
frozen up. Instead, the other way is adding some antifreeze into water to keep the water
temperature no less than 0℃.
See the following steps for how to drain water out.
(1)Loosen screws on the front panel and then remove the front panel
(2)Draw out the blind plug counter clockwise to let the chilled water flow out freely until no
water stays in. After that, place the blind plug back. (Note: put the container for foul water
beneath the drain pipe to prevent foul water from polluting the site).
A Series Modular-type Air-cooled (Heat Pump) Chiller
To Next Page
Loading...
