31
2) At the unit selection page, the on-line units are in white color and those off-line are in
grey.
3) This function setting is unavailable to the off-line units.
4) Do not activate this function for two or more units.
5) When this function has been enabled for five minutes, however the unit fails to perform
defrosting. Then, this function will be disabled, also warning “Manual defrosting stops
automatically!”
6) When this function has been enabled, however actual defrosting will be delayed for
some time.
(8)ON/OFF Memory
Operation Instructions
At the function setting page, by touching “ON/OFF memory”, the control panel will go to
the corresponding setting page. Then, by touching “OK”, default parameters will be put
into use; or by touching “Cancel” the control panel will go back to the function setting
page; or by touching “Cancel” this setting will not be saved and directly go back to the
function setting page.
(9)Energy-saving mode
Operation Instructions
At the function setting page, by touching “Energy-saving mode”, the control panel will go
to the corresponding setting page, where it can be set to be “On” or “Off”. Then, by
touching “OK”, default parameters will be put into use; or by touching “Cancel” the control
A Series Modular-type Air-cooled (Heat Pump) Chiller
To Next Page
Loading...
