Gree A Series - Page 37

32
panel will go back to the function setting page; or by touching “Cancel” this setting will not
be saved and directly go back to the function setting page.
(10)Quiet Mode
Operation Instructions
1) At the function setting page, by touching “Quiet mode”, the control panel will go to the
corresponding setting page, where it can be set to be “On’ or “Off”. Then, by touching
“OK”, default parameters will be put into use; or by touching “Cancel” the control panel
will go back to the function setting page; or by touching “Cancel” this setting will not be
saved and directly go back to the function setting page.
(11)Remote Monitoring Address
Operation Instructions
At the function setting page, by touching “Resetting”, the control panel will go to the
corresponding setting page, as shown below. Then, by touching “Yes”, default parameters
will be put into use; or by touching “No” / “Cancel”, the control panel will go back to the
function setting page.
(12)Resetting
Operation Instructions
At the function setting page, by touching “Resetting”, the control panel will go to the
corresponding setting page, as shown below. Then, by touching “Yes”, default parameters
A Series Modular-type Air-cooled (Heat Pump) Chiller