GREENWORKSTOOLS.COM GREENWORKSCOMMERCIAL.COM
14
2021-03-18
3. Fasteners
The mower and charging station have only four types of fasteners as
listed in Table 6.
Note: It is not recommended to use a power screwdriver since
excessive speed causes heating in the plastic threads and risk of
damaging the threads, reducing the service life of the component.
Table 6. Fastener types and torques
Type Visual Fastener Tool Torque
1 5 x 15 mm screw with built-in washer Torx 20 2 Nm
2 4.2 x 12 mm screw Torx 20 0.5 Nm
3 4 x 12 mm machine screw PH2 3.0 Nm
4 4 x 12 mm PTW screw Torx 20 3.0 Nm
5 Push mount cable tie N/A N/A
6 Starlock® push on fastener N/A N/A
To prevent damaging the threads in plastic components, insert the
screw fastener in the threaded hole and carefully turn the screw
counter-clockwise until it engages the existing threads in the
plastic. The screw will fall slightly by itself when the threads are
located correctly in relation to the existing threads in the plastic.
Screw in the screw to the correct torque as specified in Table 6.
To Next Page
Loading...
