GREENWORKSTOOLS.COM GREENWORKSCOMMERCIAL.COM
4
2021-03-18
1. Service checklist
Table 1 contains a checklist of actions to be taken during a yearly mower service.
Table 1. Yearly service checklist
Action Explanation
Remove the body. Clean chassis and body. See the Operator Manual.
Inspect the suspension bellows. Check that all four suspension bellows are clean and have normal
movement (compare with each other. If any suspension bellows are
damaged, replace them (see section 4.7).
Check/replace the blades and blade screws. See the Operator Manual.
Check that the blade disk can rotate freely. The 3 screws that hold the blade disk may need to be removed to
check that nothing is wrapped around the motor shaft.
Clean the charging station. Clean the exterior of the charging station using a soft brush.
Check and polish the charging plates on the mower and in the
charging station.
Disconnect the charger. Polish contact surfaces on both mower and
charging station charging plates with a fine grade emery cloth.
Perform function test of the mower and charging station. Start the mower outside charging station and check that it starts
cutting.
Charge the battery full. Place the mower with Stop-button pressed in charging station for 1
hour.
Note: Always fully charge the battery before winter storage.