Model G0561 (Mfd. Since 01/08)
-29-
Changing Blade
Speed
To change blade speeds:
1. DISCONNECT MACHINE FROM POWER!
2. Determine blade speed for your cut. The
table in Figure 35 on Page 28 is provided
as a rough guideline. Material thickness and
type of blade used will factor into FPM selec-
tion.
3. Slacken V-belt and position on pulley for
desired FPM (see Figure 36).
4. Tension V-belt as described in the V-Belt
section on Page 19
Figure 36. Illustration of V-belt placement for
FPM selection.
90
135
195
Motor Pulley Wheel Pulley
255
Blade Guides
The blade guides should be positioned approxi-
mately
1
⁄4" away from workpiece if possible. This
will help ensure straight cuts by keeping the blade
from twisting and drifting off the cut line.
To adjust blade guides:
1. Loosen blade guide knob shown in Figure
37.
2. Slide rear blade guide as close to workpiece
as possible.
3. Tighten knob.
Figure 37. Location of blade guide knob.
Blade
Guide
Knob
Blade Guides
To Next Page
Loading...
Need help?
General
