Grizzly G0704 User Manual

Model G0704 (Mfg. Since 08/11)
-33-
SECTION 5: ACCESSORIES
ACCESSORIES
H8177—Worktable with Angle
Enjoy having an economical way to support your
workpiece at an array of angles. This high-quality
tilting worktable is quick and easy to setup and
use.
Figure 35. Worktable with angle.
Figure 34. Horizontal milling worktable.
H8179—Horizontal Milling Table
Take advantage of the G0704 mill/drill 90° tilting
headstock feature. Install this lifted cast-iron hori-
zontal milling table for the correct clearance when
making those side-milling operations.
H8179
Some aftermarket accessories can be
installed on this machine that could cause
it to function improperly, increasing the risk
of serious personal injury. To minimize this
risk, only install accessories recommended
for this machine by Grizzly.
NOTICE
Refer to www.grizzly.com or the newest
copy of the Grizzly Catalog for other acces-
sories available for this machine.
G5684—R-8 Vertical Collet Rack
No more loose R-8 collets laying around in your
tool box. Organize with this handy collet rack and
you won’t be looking at each one for the correct
size. Set on your bench or mount to a wall. Holds
48 collets.
Figure 36. Model G5684 Tilt Table.

Grizzly G0704 Specifications

General

Motor	1 HP, 110V, Single-phase
Spindle Taper	R-8
Max Spindle Speed	2500 RPM
Model	G0704
Category	Drill
Spindle Travel	2"
Spindle Speed	50-2500 RPM
Table Tilt	45° Left/Right
Speed Range	50-2500 RPM