-58-
Model G0817 (Mfd. Since 05/16)
Operating Machine (Continued)
Symptom Possible Cause Possible Solution
Gullets loaded with
chips.
1. Excessive feed rate/pressure.
2. Blade TPI is too fine.
1. Reduce feed rate/pressure.
2. Install correct blade (Page 41).
Backside of blade
deformation/
cracking.
1. Excessive feed rate/pressure.
2. Blade tension too high.
3. Blade support bearing improperly adjusted.
1. Reduce feed rate/pressure.
2. Adjust blade tension (Page 28).
3. Properly adjust blade support bearing (Page 31).
Sawdust buildup
inside cabinet.
1. Blade brushes under table are worn or mis-
adjusted.
2. Clogged dust port.
3. Low CFM (airflow) from dust collection
system.
1. Properly adjust brushes; replace if necessary
(Page 62).
2. Clean dust port.
3. Inspect ducting for leaks/clogs and repair as
necessary; move dust collector closer to machine;
install a stronger dust collector.
To Next Page
Loading...
Need help?
General
