Growatt SPH4000 Installation Manual

6.3 Country setting
Growatt can provide machines of various specifications. After receiving the machines, customers can set the
corresponding specifications by dialing the LCD according to their national safety regulations.
Basic Parameter
WorkMode
WorkMode
Configuration
WorkMode
MODE Change
WorkMode
Priority
WorkMode
BackUp
Press “enter” key more than
3 seconds into setup mode
Press “down” key
to the next item
Press “enter” key more
than 1 seconds to make sure
Default Set
WorkMode
Auto Test
WorkMode
ExportLimit
WorkMode
Chart 6.1
Caution :
When you setting the DIP, you must turn off PV switch, AC
breaker and Battery to make sure all of the power are off.
Caution:
1. After setting the DIP, please power on the inverter and check
the model display (show as 6.3.1). If the model display is match
what you want, it means your setting is successful.
2. You need to calibrate the time that the machine is showing
after inverter starts up.
If the country is set incorrectly, please shut down the inverter

Growatt SPH4000 Specifications

General

Model	SPH4000
Category	Inverter
Rated Power	4000 W
Max. DC Voltage	550 V
MPPT Voltage Range	120 V - 500 V
Number of MPPTs	2
AC Output Voltage	230 V
Frequency	50/60Hz
Efficiency	97.5%
Start Voltage	150 V
Nominal DC Voltage	360V
Max. Input Current per MPPT	11 A
AC Nominal Power	4000 W
Max. AC Apparent Power	4000 VA
AC Voltage Range	180 V - 280 V
Power Factor	0.8 leading to 0.8 lagging
THDi	<3%
AC Connection Type	Single phase
Max. Charge/Discharge Power	4000 W
Nominal Battery Voltage	48 V
Communication with BMS	CAN/RS485
Operating Temperature Range	-25°C to +60°C
Protection Degree	IP65
Topology	Transformerless
Weight	25 kg
Max. PV Input Voltage	550 V
Cooling Method	Natural Convection