Fig 5.10 Floor-mounted installation
5.4.2 Wall-mounted Installation
The WIT 50-100K Storage/Hybrid Inverters can be mounted on the wall. For wall-mounted
installation, you need to purchase the mounting bracket from Growatt. Determine the hole
positions for installing the mounting bracket using the marking-off template and drill holes. Align
the mounting bracket with the hole positions and insert nuts (φ12) into the holes. Secure the
mounting bracket by tightening the screws. Then install the WIT Inverter on the bracket and
secure it to the wall. Please refer to Fig 5.11 for the dimensions of the marking-off template and
Fig 5.12 for the wall-mounted installation.
Fig 5.11 Marking-off template for wall-mounted installation
To Next Page
Loading...
