11.5.6 Shaft with rotor assembly removal
1. Remove the O-ring (39).
TM084263
2. Remove the 4 M10x25 screws (183).
3. Fix the lifting eye into the threaded hole of the shaft end.
4. Lift the rotor with shaft, together with the lower bearing housing, out of the stator housing. During the lifting process, make sure that the
inner cable harness can not be damaged, torn or pinched between the rotor and the stator housing. Use spacers to prevent damage.
5. Immediately after lift-out, fasten the inner cable harness so it cannot be damaged later on.
6. Carefully put the shaft with rotor down on an empty pallet.
49
English (GB)
To Next Page
Loading...
