12.18 Mounting the power and sensor cables
1. Pull the power cable cable bullets through the bullet holder of the bracket for wire termination (522). The cable bullets must be positioned
next to the main terminal board (226).
TM084608
C Cable bullet assembly
S Stripped cable end in case of EMC cable
2. Mount the cable clamps (409) on the bracket for wire termination (522) with the screws (93) fixing the power cables.
3. Tighten the screws with the required torque.
4. Lead the power cable cores behind the leg of the bracket for wire termination (522) and screw on the cable lugs according to the
connection diagram. Secure the cable lugs with washer (405) and M8 nut (406).
TM084609
TM084610
Terminal board assembly - 2-cable version
Terminal board assembly - 3-cable version
Nut Nut Nut Nut
Washer Washer Washer Washer
Stator cable lug Stator cable lug Stator cable lug Power cable lug
Connection bar Washer Washer
Power cable lug - Nut Nut
Washer Washer
Nut Nut
84
English (GB)
To Next Page
Loading...
