Grundfos SE - Terminal Bracket Assembly

12.15 Terminal bracket assembly
1. Mount the bracket for screen termination (522) on the bracket for wire termination (522) with screws (105A) and serrated lock washer (27.)
93
226
230
1
27
105A
1084
176C
522
522
TM084502
2. Mount the terminal board (226) on the assembled bracket for wire termination (522) with screws (93).
3. Mount the terminal block (176C) on the assembled bracket for wire termination (522) with screws (1084).
4. Mount the preassembled terminal bracket on the upper bearing housing with screws (1) and serrated lock washer (230B).
Related information
7. Tightening torques and lubricants
8.2.1 Standard sensor version
8.2.2 Sensor version V1
8.2.3 Sensor version V2
80
English (GB)