Grundfos SE - Bearing Cover Assembly

12.5 Bearing cover assembly
1. Mount and press the radial shaft seal (401) into the bearing cover (59). Use the insertion tool. The check mark indicates the proper
orientation of the shaft seal.
401
401
59
TM084446
Apply grease to the marked area
2. Apply grease on the lip of the radial shaft seal and on the shaft. Greasing areas are indicated on the image above.
3. Mount the assembled bearing cover (59) on the lower bearing bracket. Apply grease to the marked area.
59
183
TM084445
Apply grease to the marked area
4. Insert the four screws (183) and tighten them to a stop.
5. Tighten the four screws to the required torque. Always go in a sequence, tightening one screw then the opposite.
Related information
7. Tightening torques and lubricants
64
English (GB)