7. Grease the first bearing (153) or apply grease between the inner and outer dummy bearing according to the figures below.
TM084436
TM084437
Correct bearing orientation if P2 < or = 41 kW
TM084438
Correct bearing orientation if P2 > 41 kW
A 100% grease filling
B 50% grease filling
Press on only the outer ring when fitting the bearing into the bearing bracket!
8. Mount the second lower bearing (153).
9. Grease the bearing according to the figures above.
10. Mount the O-ring (39) on the bearing bracket (155). The O-ring must be lubricated.
11. Mount the wire cover (159) on the bearing bracket (155).
TM084439
Related information
7. Tightening torques and lubricants
61
English (GB)
To Next Page
Loading...
