Grundfos SE - Page 87

3. Insert the screws (67) and serrated lock washers (67B) to the motor top cover (164A) and tighten them to the required torque. Tightening
sequence:
4
6
2
7
3
5
1
8
TM084495
4. Grease the cable inlet O-rings (157D) and mount the cable bullets.
183
168
157D
TM084194
5. Mount the upper cable inlet parts (168) on the motor top cover (164A) with its screws (183).
6. Tighten the screws (183) to the required torque.
87
English (GB)