How to fix no sound on Grundig Receiver?
If there is no sound from your Grundig Receiver, ensure that the sound is not muted and that the Euro-AV cable is correctly connected. Also, check that the receiver volume is not set too low and increase it as needed.
What to do if the Grundig DTR 1560 MICRO remote control does not work?
If your Grundig Receiver remote control isn't working, first ensure that batteries are correctly inserted or replace them with new ones. Also, make sure you are pointing the remote control directly at the infrared sensor on the receiver.
Why does my Grundig Receiver say 'Faulty signal'?
If your Grundig Receiver displays a 'Faulty signal' message, it indicates that the antenna is either not properly connected or not correctly positioned. To resolve this, ensure the antenna is securely connected. You may also need to move the antenna around to find the optimal position for signal reception.
What to do if Grundig DTR 1560 MICRO Receiver displays »Antenna short circuit«?
If your Grundig Receiver displays 'Antenna short circuit', this means the antenna has excessive current consumption or a short circuit. Immediately switch off and unplug the device. Then, unplug the antenna and set the »Active antenna« option to »Off« in the »General« menu.
Why is there no picture on my Grundig DTR 1560 MICRO Receiver?
If you are not getting a picture on your Grundig Receiver, the Euro-AV (Scart) cable may not be properly connected, or there may be incorrect settings in the »Video output TV« menu. Ensure the Euro-AV cable is correctly connected and adjust the menu settings as needed.
How to fix Grundig DTR 1560 MICRO Receiver when no function and mode indicator not lit?
If your Grundig Receiver is not working and the mode indicator is not lit, it is likely that the power cord is not connected correctly. Ensure the power cord is properly connected.
How to correct the time on a Grundig Receiver?
If the time is not displayed correctly on your Grundig Receiver, it is likely due to a deviation from your local time. Correct the difference in the receiver's settings.
To Next Page
General