Grundig DTR 1560 MICRO - Manual Station Search

ENGLISH
25
Manual station search (expert search)
You enter the channel to be searched directly during the manual
search.
1 In the main menu, select »Search for Channels« with »P-« or
»P+« and press »OK« to confirm.
Note:
You only need to change the antenna settings if the antenna
type (passive, active) has changed.
2 Select »Manual Search« with »P-« or »P+« and press »OK« to
confirm.
3 Select »Frequency« with »P-« or »P+«.
4 Select the channel with »
Ǹ
« or »
Ƿ
«, or type the frequency
directly into the »Frequency (MHZ)« line using the number
buttons.
5 Select »Bandwidth« with »P-« or »P+«.
6 Select the wavelength with »
Ǹ
« or »
Ƿ
«.
Note:
Select the »All« option in »Channels to search for« if you would
also like to receive encoded stations.
7 Select »Start Scan« with »P+« or »P-« and press »OK« to start
the search.
– A message will appear once the search has ended.
8 Press »
Ǹ
« or »
Ƿ
« to select one of the following options:
»Yes, add new channels«
– The stations that have been found are added to the station list.
»Yes, replace old channellist«
– The old station list is overwritten with the new stations.
»No, discard new channels«
– The new stations are not stored.
9 Press »OK« to confirm.
10 Press »i« to finish the setting.
ADDITIONAL FUNCTIONS
_____________________________