38
Master
®
Pin Lock (RB975)
The pin lock substitutes for the clevis pin at either
or both mounting points of the GTO/PRO 1000
series operator arm. Helps prevent theft of the
operator arm while allowing quick release of the
operator.
The pin lock can be inserted in the chain brackets of
the GTO/PRO SL-1000 to prevent unauthorized
removal of the quick release pins.
Column Mount Lock Receiver (433IH)
For mounting the Automatic Gate Lock or
Bulldog Pedestrian Lock on areas with
limited space between the gate and post, such
as brick columns, walls, etc.
4" (O.D.) Round Post Bracket Adapters (RB469)
These adapters are necessary when mounting the 4" post bracket to a 4" (O.D.) gate post.
Two required for each gate. Use with 4" Post Bracket (RB464).
6
5
/
8
" (O.D.) Round Post Bracket Adapters (RB467)
Similar to RB466, used with 6
5
/
8
" (O.D.) gate post. Two required for each gate.
4" (O.D.) Post Bracket (RB464)
Recommended for mounting GTO/PRO 2000 to a 4" gate post.
Mounting Accessories
GTO
Automatic Gate Lock (FM144) for closed position pull-to-open
applications
A MUST for added security. Driven by a 4 amp solenoid, the plated
steel bolt lock has a zinc plated steel housing. The horizontal electronic
lock is used with all GTO swing gate operator systems for additional
security and stability. Comes with a keyed manual release.
GTO
Automatic Gate Lock (FM142) for open position or push-to-open
applications
Similar to FM144 but used to secure gates in the open position, or for
push-to-open gate applications (not shown).
AUTOMATIC
GATE LOCK
®
ELECTRONIC SECURITY LOCK
Locking Accessories
To Next Page
Loading...
