41
Installation Check-Off List
(Installer should verify that each item has been completed)
____ Safety instructions have been explained and given to the end user.
____ All power cables, receiver cables and the transformer plugs are secure to assure contact is made for proper perfor-
mance. (petroleum jelly applied to ends)
____ Customer/end user has been instructed on proper use of transmitter.
____ Customer/end user has been instructed on program features of control board and how to either open or close gate in the
event of low-voltage lock-out.
____ Customer/end user has been instructed on how to remove operator arm in the event of an emergency, via manual
disconnect.
____ Customer/end user has been instructed to use silicon spray on the push/pull tube and front and rear mounts for operator
maintenance and service prevention.
____ Trouble shooting guide has been reviewed and Installation Manual has been left with customer/end user.
____ All caution signs and labels have been placed or hung in a highly visible area.
____ A photo has been taken of completed installation from both front and back of the gate, and dated.
____ Review the Accessory Catalog with the customer/end user.
____ Ask customer/end user to fill out customer support card and mail it to GTO.
____ Ask customer/end user to keep all receipts, installation manuals etc. for future reference.
To Next Page
Loading...
